|
Post by Slacker on Nov 22, 2013 18:15:40 GMT -8
|
|
|
Post by Slacker on Nov 25, 2013 17:37:10 GMT -8
got the old sheet metal off .. and here's why I recommend doing the whole panel instead of a patch clearly you can see the rust !! also .. it allows you to clean and repair the complete inner . because of the previous owners "repair" , we had to replace the outer wheel house on both sides and with everything all cleaned and prepped , time for some POR 15 and wheel house "glued" .
|
|
|
Post by Slacker on Nov 26, 2013 18:19:41 GMT -8
with everything cured , the rear 1/4r panels are now fit and epoxied into place also got the fronts on
|
|
|
Post by Slacker on Nov 27, 2013 16:53:25 GMT -8
and last but not least , our new rear inner panels installed and everything back together today .. Erik picked up , and another happy customer .
|
|
|
Post by Slacker on Apr 4, 2014 17:20:34 GMT -8
well Erik is back for the 5Vzfe 3.4L install busy working on Erik's engine Erik has opt. for our black painted headers , as well as our new clutch , filters , belts , plugs and t/belt and water pump .. so busy getting everything prepped and cleaned before the install .
|
|
|
Post by Slacker on Apr 5, 2014 15:59:24 GMT -8
just a little today .. pulled the Alt apart to check condition of brushes .. all good cleaned up and ready to install also , got the starter pulled apart and checked contacts .. all good bottom mount hole drilled and now ready to install
|
|
|
Post by Slacker on Apr 23, 2014 17:30:51 GMT -8
more cleaning and prepping today . got a bunch of parts blasted , and painted , including the oil pan . also got the bottom end buttoned up . drilled the dipstick , tapped the old dipstick hole , new pickup , and attached the clean pan , oil pressure sensor , oil filter flipped it back over , and started the top end .. as well as new water pump and timing pieces and added some powder coated pieces
|
|
|
Post by Slacker on Apr 25, 2014 19:34:12 GMT -8
|
|
|
Post by Slacker on May 9, 2014 17:25:50 GMT -8
well Erik has made it to the shop .. we got started removing the old engine and a little cleaning
|
|
|
Post by Slacker on May 12, 2014 17:04:31 GMT -8
cut the drivers fender built a trey and welded it in . And now I have enough room for the correct evap can
|
|
|
Post by Slacker on May 14, 2014 15:53:31 GMT -8
new battery trey prepped and installed and also got the sliders ready for powder coat
|
|
|
Post by Slacker on May 15, 2014 16:26:38 GMT -8
3.4L sittin' in it's new home
|
|
|
Post by Slacker on May 20, 2014 17:22:25 GMT -8
all done the engine install and time for some wiring installed a smoothie cowl today as well
|
|
|
Post by Slacker on May 23, 2014 17:42:46 GMT -8
got the full "custom " exhaust built , ALL in house 2.5" mandrel bent . header pipe being built and muffler and all installed cant wait to hear it
|
|
|
Post by Slacker on May 24, 2014 17:03:58 GMT -8
and the wiring has begun
|
|